SAFETY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
20
ZI-ABH1500D / ZI-ABH1700D
10.3
Technical details
ZI-ABH1500D
ZI-ABH1700D
Voltage
230 V / 50 Hz
230 V / 50 Hz
Motor power
1500 W
1700 W
Hits / minute
1900
1900
Weight
14 kg
18,5 kg
Single hit power
45 J
65 J
Sound-pressure level L
PA
(
K=3dB(A))
93 dB(A)
84,77 dB(A)
Sound-power level L
WA
(K=3dB(A))
105 dB(A)
105 dB(A)
Vibration a
h, CHeq
(K=1,5 m/s
2
)
20,706 m/s²
21,343 m/s²
Tool dimensions
30x410mm (hexagonal)
30x410mm (hexagonal)
Protection class
II
II
Protection mode
IP 20
IP 20
The declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
WARNING
The vibration emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is use!
11
SAFETY
11.1
Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the assembly
instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Chiselling in concrete, brick and stone.
Any manipulation of the machine or its parts is a misuse, in this case ZIPPER-
MASCHINEN and its sales partners cannot be made liable for ANY direct or indirect
damage.
WARNING
Use only chisels allowable for this machine!
Never use a damaged chisel!
Use the machine never with defective or without mounted guard
HIGHEST RISK OF INJURY!
Ambient conditions
The machine may be operated:
humidity
max. 70%
temperature
+5°С to +40°С (+41°F to +104°F)
The machine shall not be operated in areas exposed to increased fire or explosion hazard.
