CLEANING, MAINTENANCE, STORAGE, DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
35
ZI-ASA550ESA
N O T I C E
Only a regularly serviced and well maintained machine can be a satisfactory
resource. A lack of maintenance and care can lead to unforeseeable accidents
and injuries.
Repairs that require special expertise should only be carried out by trained
professionals.
Improper intervention may damage the machine or endanger your
safety.
14.2.1
Servicing and maintenance plan
Intervall
Component
Measure
Before operating the
machine, after every
maintenance, servicing
and after prolonged
storage
Nuts
Bolts
Check if securely tightened
Sawdust collecting bag Check, if necessary empty it
Filter bag
Check, if necessary, change the filter
bag
Extraction hose
Check for damage
Wires
Check for damage
ON-OFF-Switch
Check for damage
Switch housing
Check for damage
Electric motor
Check for damage
Fan housing
Check for damage
Safety devices
Check the condition
Security stickers
Check the condition. If necessary
replace them.
Monthly
dust collector hood
Check for deposits especially on the
protective fence.
If necessary clean it.
14.2.2
Emptying the sawdust collecting bag
Empty the chip collection bag after completing the work but at the latest when the maximum
filling volume of 65 l has been achieved.
Procedure:
Attention: Disconnect the machine from power supply!
Shake the sawdust collecting bag and let the dust settle for 10 minutes.
Hold the filled sawdust collecting bag with your hand.
Open the quick release fastener.
Disassemble the sawdust collecting bag and dispose the contents in an
environmentally friendly manner.
Replace the sawdust collecting bag and fix it with the quick release fastener.
14.2.3
Changing the sawdust collecting bag
Procedure:
Attention: Disconnect the machine from power supply!
Before changing the sawdust collecting bag, the machine must be switched off at least
10 minutes before, so as to allow dust particles to settle.
Hold the filled sawdust collecting bag with your hand.
Open the quick release fastener and remove the dust collecting bag.
Replace the sawdust collecting bag and fix it with the quick release fastener.
Only use sawdust collecting bags that match the dimensions of the machine. Only use 100
percent tight chip trap bags.
