ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-ASA550ESA
impeller for eventual damage. Damaged parts have to be replaced immediately, no operation
of the machine in the meantime!
Hazard of electric shock
Undetected malfunctions in the power supply and/or the connected wood working machine
might result in electric shock when touching the machine. Ensure proper electric installation,
and let it check periodically by a trained electrician.
Danger due to unintended machine start-up
Eliminate this risk by disconnecting the machine before you perform any checks or activities
on the machine.
Hazard of inhaling toxic wood dust
Especially wood dust arising from chemically treated wood and/or lacquer/paint are harmful
when inhaled. Therefore let the dust settle for 10 Minutes before you change the dust collector
bag and wear a suitable breathing mask if required.
These risks can be minimized if all safety regulations are applied, the machine is properly
maintained and cared for and the machine is operated as intended and by appropriately
trained personnel.
Notwithstanding all safety regulations, your common sense and appropriate technical
suitability/training will remain the most important safety factor in the fault-free operation of
the machine. Safe operation depends foremost on you!
12
ASSEMBLY
12.1
Delivery content
Please check the product contents immediately after receipt for any eventual transport
damage or missing parts.
12.2
Workplace requirements
The workplace has to fulfill the requirements.
The ground has to be even, in level and hard. It must be suitable at least to weight it with
double weight per square meter than the machines net weight.
The chosen workplace must have access to a suitable electric supply net hat complies with
the machines requirements.
12.3
Transportation
Transport the machine in its packaging to the installation site.
Only use the handle on the motor housing for manoeuvring the machine.
12.4
Power supply
W A R N I N G
Dangerous electrical voltage! The connection of the machine as well as
electrical inspections, maintenance and repair may only be carried out by
qualified personnel or under guidance and supervision of a qualified electrician!
C A U T I O N
When working with non-grounded machines: Severe injury or even death may arise
though electrocution!
Therefore: The machine must be operated at a grounded power socket.
The connection of the machine to the electric power supply and the following checks have to
be carried out by a respectively trained electrician only.
