OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
29
ZI-BTM130
12
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used.
Check in particular the safety equipment, electrical controls, electric cables and screwed connection for
damage and if tightened properly. Replace any damaged parts before operating the device.
Operation instructions
WARNUNG
Perform all machine settings with the machine being disconnected
from the power supply!
HINWEIS
Install and operate the concrete mixer on a solid and flat surface
(making sure it does not fall over).
Keep the working area clear by tripping hazards.
It should be possible to swivel the drum to the right and left. There must
be sufficient space for a wheelbarrow under the drum, so that it can be
emptied.
The mixer drum to be only filled and emptied when the engine is
running.
Pay attention to the rotation direction of the mixer drum.
Do not move the concrete mixer during operation!
Regularly check the contact pressure of the swiveling wheel. If it were
necessary, re-tighten the tension spring.
Operation
Switch On-Off:
Plug the machine into a socket.
Push „I“ (green button) to switch on
Push „0“ (red button ) to switch off
Swiveling the drum:
To swivel the drum, pull back the swiveling
wheel (1), so that the drum can be moved (2).
When the drum is in the desired position, lock
the swiveling wheel again.
