MAINTENANCE
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
31
ZI-BTM130
13
MAINTENANCE
ATTENTION
Don’t clean or do maintenance on the machine while it is still connected to the
power supply:
Damages to machine and injuries might occur due to unintended switching on of
the machine!
Therefore: Switch the machine off and disconnect it from the power supply be-fore
any maintenance works or cleaning is carried out
The machine does not require extensive maintenance. If malfunctions and defects occur, let it be
serviced by trained persons only.
Before first operation as well as later on every 100 operation hours you should lubricate all connecting
parts (if required, remove beforehand with a brush all dust).
Check regularly the condition of the security stickers. Replace them if required.
Check regularly the condition of the machine.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
NOTICE
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
Maintenance plan
After each workshift:
Clean the machine, especially the drum
After 25 hours of operation
Grease the sprocket
Check tension of the v-belt
V-Belt adjusting
Remove the cover of the motor housing, check the belt tension (on pressing
the belt with the finger, it should yield by approx. 5mm.)
Belts are wear and tear parts that must be replaced after a certain period. If
necessary, detach the screws on the motor, replace the belt, adjust the
correct tension and tighten the screws again.
Reinstall the motor cover.
Transport
Set the filling opening downwards.
Lift the machine at the transport handles and move the machine
During transportation by motor vehicle, remove the screws and fold the stands.
Lock the mixer with a strap to prevent displacement
