SAFETY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
21
ZI-HST40V-AKKU
12
SAFETY
12.1
Intended Use
The machine must only be used for its intended purpose! Any other use is deemed to be a case of
misuse.
To use the machine properly you must also observe and follow all safety regulations, the assembly
instructions, operating and maintenance instructions lay down in this manual.
All people who use and service the machine have to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident prevention regulations in force in your area.
The same applies for the general rules of occupational health and safety.
The machine is used for:
Cutting and trimming hedges and bushes which have a maximum branch thickness of Ø22 mm and
for maintaining hedges and bushes in the private sector.
This machine is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the machine by a person responsible for their safety.
Never allow children or people unfamiliar with these instructions to use the machine. Supervise
children. This will ensure that children do not play with the machine.
Any manipulation of the machine or its parts is a misuse, in this case
ZIPPER-MASCHINEN
and
its sales partners cannot be made liable for ANY direct or indirect damage.
W A R N I N G
Before using read the user instructions of accessories (charger, battery)
Use only cutting tools allowable for this machine!
Never use damaged cutting tools!
Never use the machine with defective or without mounted guard
The removal or modification of the safety components may result in damage to
equipment and serious injury!
HIGHEST RISK OF INJURY!
Prohibited use:
The operation of the machine outside the stated technical limits described in this manual is forbidden.
The operation of the machine without provided protective devices is prohibited
The use of the machine not being suitable for the use of the machine and not being certified is
forbidden
The use of the machine not according with the required dimensions is forbidden.
Any manipulation of the machine and parts is forbidden.
The use of the machine for any purposes other than described in this user-manual is forbidden.
It is not allowed to leave the immediate work area during the work is being performed.
