TRANSPORT
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
23
ZI-RMM94H
23
- Serious risk of injury with possible fatal consequences in the event of tire blowouts during the
inflation process!
o Therefore NEVER exceed the maximum recommended tire pressure by the tire manufacturer.
o Before inflating check tires and rims for perfect condition.
o During the inflation check condition and pressure again and again
Hazard warnings
Despite intended use, certain residual risks remain. Due to the design and construction of the
machine, hazardous situations may occur which are identified as follows in these operating
instructions:
D A N G E R
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
W A R N I N G
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
C A U T I O N
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
N O T I C E
A safety note designed in this way indicates a potentially dangerous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, their sound common sense and corresponding technical
suitability/training are and remain the most important safety factor in the error-free operation of
the machine. Safe working depends first and foremost on you!
13
TRANSPORT
W A R N I N G
Damaged or insufficiently strong hoists and load slings can result in serious injury or
even death. Before use, therefore, check hoists and load slings for adequate load-
bearing capacity and perfect condition. Secure the loads carefully. Never stand under
suspended loads!
To ensure proper transport, also observe the instructions and information on the transport
packaging regarding centre of gravity, attachment points, weight, means of transport to be used
and the prescribed transport position, etc.
Transport the machine in its packaging to the installation site. To manoeuvre the machine in the
packaging, use a pallet truck or forklift truck with appropriate lifting capacity. For unproblematic
unloading, at least three additional persons are required due to the high weight or the use of a
forklift/crane with appropriate lifting gear and qualified personnel for operation.
14
ASSEMBLY
Checking Scope of Supply
Check the machine immediately after delivery for transport damage and missing parts.
