OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-STE2000IV
10.1.3
Check the air filter
Check the core of the air filter, ensuring that it is
clean and performs well.
Dismantle the repair cover, loosen the screw on
the cover of the air filter, and then dismantle the
cover of the air filter to check the core.
Please clean or change the core if necessary.
10.2
Start the engine
Totally turn the valve to the “ON” position clockwise and ESC to the position “0” =
OFF.
Turn the switch of the engine to the “ON” position. (Fig. L)
Turn the pulling pole of the air-blocking valve to the “START” position. (Fig. M)
Pull the starting hold (Fig. N) slightly until you
feel the pressure, then release the hold slowly by
hand.
When the engine is warming up, turn the pulling
pole of the air-blocking valve to the “RUN”
position.(Fig. O)
1 – Run / operate (Fig. O) 2 – air-blocking valve (Fig. O)
3 –operating position
Do not run the engine without the
air filter, or else filth will enter the
engine through carburetor,
resulting in quick wear and tear of
the engine.
A – Screw of the repair cover (Fig. I)
B – Repair cover (Fig. I)
C – Air filter (Fig. J)
D – Cover of the air filter (Fig. J)
E – Screw of the air filter (Fig. J)
F – Core of the air filter (Fig. J)
I M P O R T A N T
when the engine is hot or the
environmental temperature is
relatively high turn the pulling pole
of the air-blocking valve to the
“RUN” position.
Do not let the starting hold (Fig. N)
rebound, and release it slowly by
hand.
If the engine can not restart after
halting, check the oil level ahead of
other failures.
Summary of Contents for ZI-STE2000IV
Page 10: ...TECHNIK TECHNIC TEHNIKA ZIPPER MASCHINEN GmbH www Zipper Maschinen at 10 ZI STE2000IV B A...
Page 11: ...TECHNIK TECHNIC TEHNIKA ZIPPER MASCHINEN GmbH www Zipper Maschinen at 11 ZI STE2000IV 2 A 1 2...
Page 98: ...PRODUKTBEOBACHTUNG ZIPPER MASCHINEN GmbH www Zipper Maschinen at 98 ZI STE2000IV...
