OPERATION
31
ZI-STE3000IV
13.1.2
Requirements for the installation site
Place the machine on a level, solid surface to prevent the machine from tipping over.
When dimensioning the required space, take into account that the operation must be possible without
restrictions at all times.
13.2
Pre-operation check
13.2.1
Check engine oil level
N OTE
The machine is delivered without engine oil and fuel!
Engine oil 15W40 must be filled before first use!
N OTE
A too low oil level will damage the engine and shorten the life of the machine. Therefore,
check the engine oil level before every start and top up the engine oil if necessary.
NOTE:
Engine does not start with low oil (low oil alarm lights up).
See capture maintenance => engine oil change.
13.2.2
Check fuel tank level
N OTE
Observe the safety regulations for fuel control.
Filter the fuel during refuelling to prevent
foreign particles from entering the combustion chamber. Wipe up leaked fuel.
WARNIN G
Never refuel if the engine is running
•
Place the machine on a firm and flat surface.
•
Open the fuel filler cap (1).
•
Check the fuel filter (2).
NOTE:
Never refuel without fuel filter!
•
Refuel with unleaded gasoline, until the max. fill-
ing level (F=full) is reached.
•
Close the fuel filler cap (1) tightly after refuelling.
13.2.3
Grounding
The machine is designed with the protective measure protective separation with potential equalization
in the IT network. A grounding by means of a grounding screw and a grounding spike is thus designed
to discharge static charges. For this purpose, connect the grounding screw of the power generator to
a grounding spike (grounding cable cross-section 16mm²). If other protective measures are required,
clarify them with a qualified electrician and have them documented in order to check their effective-
ness
..
13.3
Information on Initial Start-up
13.3.1
Test Run Initial Start-up
Make sure to treat the machine with care, when using it for the first time.
•
Let the machine run idle for about 3 minutes before connecting the generator with consumer
load.
•
Pay attention to abnormal noises.
•
Pay attention to the exhaust fumes (too black, too white)?
If these points meet the demands, the machine can be used further. Otherwise stop the machine and
find the cause of the problem.
