OPERATION
33
ZI-STE3000IV
•
At
cold start
set the choke (3) to position „START”.
•
If the engine runs smoothly set the choke (3) to position
„RUN”.
•
At
warm start
(the engine was running and is still warm) set
choke (3) to position „RUN“.
If the engine fails to start after 5 attempts, set the choke to
position "START" and try again.
•
Start the engine with the recoil starter.
Grab the starter handle (4) and pull it out slowly. The re-
sistance becomes strongest at a certain point. This point cor-
responds to the compression point. Let the rope roll back a
little from this point and then pull it out powerfully.
Slowly return the starter handle (4).
If the engine does not start, try again.
Normally start: 3-4 attempts.
13.6.2
Switch the machine off
CAU TION
In case of emergency stop the machine directly with the ON-OFF switch.
Under normal circumstances, switch off the machine as follows:
•
Shut down the connected devices and disconnect them from the machine.
•
Let the machine run for some time without connected devices to cool down.
•
Switch off the machine by putting the ON-OFF switch to position „OFF“.
•
At longer breaks: Let the machine run for some time without connected devices to cool down.
•
Thereafter close the fuel tap by turning to position „OFF“. The engine runs until the remaining
fuel is consumed in the carburettor.
•
Switch off the machine by putting the ON-OFF switch to position „0“.
13.6.3
ECO-mode
The ECO-mode is recommended to reduce fuel consumption
during operation.
With the activated ECO-mode, the machine automatically re-
duces the engine speed depending on the load. This results in
less fuel consumption.
NOTE:
In case of low power output, the ECO-mode can be acti-
vated (switch (1) in position "I").
In case of high power output and DC operation, the ECO-mode
must always be deactivated (switch (1) in position "0").
13.6.4
Teleskope handle
•
By pressing the unlocking button (2), the length of the tele-
scope handle (1) can be adjusted.
