TRANSPORT
30
ZI-STE3000IV
Direct electrical contact may cause electric shock.
Never touch the unit with wet hands. Provide adequate grounding.
•
Hearing damage
A longer stay in the immediate vicinity of the running unit may cause hearing damage.
Wear ear protectors!
11.7.2
Hazardous situations
Due to the structure and construction of the machine, hazardous situations may occur which are identified
in these operating instructions as follows:
DAN G ER
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARN IN G
Such a safety instruction indicates a potentially hazardous situation which, if not avoided,
may result in serious injury or even death.
CAU TION
A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
N OTE
A safety note designed in this way indicates a potentially dangerous situation which, if
not avoided, may result in property damage.
Regardless of all safety regulations, your common sense and your appropriate technical aptitude/training
are and remain the most important safety factor in the error-free operation of the machine.
Safe working
depends on you!
12
TRANSPORT
•
Always switch off the engine when transporting and refuelling the machine!
•
Ensure that the fuel tap and the ON-OFF switch are turned to position “OFF”.
•
After operation, allow the machine to cool down for at least 15 minutes.
Transport of the machine in a vehicle:
•
Check that no fuel can leak from the tank. Ensure that the fuel filler cap is tightly closed.
•
When transporting the machine in a vehicle, ensure that the machine is appropriately secured!
The machine must be carried and transported in an upright position to avoid oil or fuel leakage.
•
If the machine is in a vehicle, do not start the engine. Take the machine out of the vehicle and
run it outdoors only.
•
Protect the machine from excessive heat during transport. If the machine remains in a closed
vehicle for a long time, the fuel may ignite due to overheating.
13
OPERATION
Only operate the machine when it is in perfect condition. Before each operation, a visual inspection of
the machine must be carried out.
13.1
Preparation
13.1.1
Checking delivery content
Check the delivery immediately for transport damage and missing parts. Report any damage or miss-
ing parts to your dealer or the shipping company immediately. Visible transport damage must also be
noted immediately on the delivery note in accordance with the provisions of the warranty, otherwise
the goods are deemed to have been properly accepted.
