ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
30
ZI-WP400TN
5. Connecting pivoting log carriage and base
frame
Place the pivoting log carriage on the ground with
the legs inside the base frame and put one end of
the cross brace to the outside as shown in Fig. E.
Secure them using M8×40 bolts, washers and lock
nuts on both sides.
Fix the other end of the cross brace from the inner
side of the base frame using M8×70 bolts, washers
and lock nuts on both sides.
6. Assembly inner saw blade cover
Slide the shaft through the centre hole of the inner
saw blade cover and align the other holes with
those on the motor plate as shown in Fig. F.
Secure the shaft with three M8×20 screws, wash-
ers and locknuts on the upper side and one M8×45
screw, washer and locknut on the lower side.
