SAFETY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
23
ZI-WP500TN
12
SAFETY
This section contains information and important notes on safe start-up and handling of the
machine.
For your own safety, read these operating instructions carefully before putting the
machine into operation. This will enable you to handle the machine safely and prevent
misunderstandings as well as personal injury and damage to property. In addition,
observe the symbols and pictograms used on the machine as well as the safety and
hazard information!
12.1
Intended use of the machine
The machinery is intended exclusively for the following operations:
For cutting round wood, logs and other woody materials.
Information on the condition of the workpieces:
-
There must be no foreign objects, such as nails, in the workpiece!
-
Only one workpiece may be machined at a time, regardless of its dimensions!
-
It is not allowed to process several and also no bundles of cut material.
-
To prevent wedging and recoil of the cut material, bent cut material must always be
placed in the log carriage so that the outer edge faces the machine.
ZIPPER-MASCHINEN
assumes no responsibility or warranty for any other use or use beyond this and
for any resulting damage to property or injury.
12.1.1
Technical Restrictions
The machine is intended for use under the following ambient conditions:
Relative humidity:
max. 65 %
Temperature (for operation)
+5° C bis +40° C
Temperature (for storage and/or transport) -20° C bis +55° C
12.1.2
Prohibited Use / Forseeable Misuse
-
Operating the machine without adequate physical and mental aptitude
-
Operating the machine without knowledge of the operating instructions
-
Changes in the design of the machine
-
Remove the safety markings attached to the machine
-
Modify, circumvent or disable the safety devices of the machine
-
Operating the machine in a potentially explosive environment (Machine can generate
ignition sparks during operation)
-
Operating the machine outside the technical limits specified in this manual
-
Machining of materials with dimensions outside the limits specified in these instructions.
-
Use of tools that do not comply with the safety requirements of the standard for
machine tools for woodworking (EN847-1).
-
Use of saw blades made of HSS steel.
-
Use of saw blades with a lower max. speed than the machine.
The improper use or disregard of the versions and instructions described in this manual will result in
the voiding of all warranty and compensation claims against Zipper Maschinen GmbH.
12.2
User Requirements
The machine is designed for operation by one person. The physical and mental aptitude as well as
knowledge and understanding of the operating instructions are prerequisites for operating the
machine. Persons who, because of their physical, sensory or mental abilities or their inexperience or
ignorance, are unable to operate the machinery safely must not use it without supervision or
instruction from a responsible person.
