ASSEMBLY
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
28
ZI-WP500TN
1. Assembly wheel axle
Place the wheel axle (1) on the rear side of the base
frame (2) and align the bore holes (see Fig. E, Pic. 1).
Secure the wheel axle (1) to the base frame (2) using
a total of four M8×20 bolts (3), eight washers (4) and
four nuts (5) (see Fig. E, Pic. 2).
2. Assembly wheels
Slide two washers (7), a wheel (8) and a third washer
(7) onto the wheel axle (6) one after the other (see
Fig. F, Pic. 1-3).
To secure, insert a cotter pin (9) into the bore hole of
the wheel axle (6) and bend its lower ends apart (see
Fig. F, Pic. 4).
Repeat the same steps for the second wheel.
