OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
30
ZI-WP500TN
15.1.1
Unlocking the machine
NOTICE:
the locking plate (1) must be released
before start-up of the machine (see Fig. H)!
15.1.2
Setting the log ruler
1.
Loosen the star screw (1) so that the log ruler (2)
can be pulled out (see Fig. I, Pic. 1).
2.
Use the scale to set the desired length of the
workpiece (see Fig. I, Pic. 2).
3.
Turn the log ruler (2) clockwise to the top (see Fig.
I, Pic. 3).
4.
For fixation, retighten the star screw (1) (see Fig. I,
Pic. 4).
15.2
Operating
15.2.1
Start/Stop
Starting the machine: press the green
˝I˝
button on the ON-OFF switch.
Stopping the machine: press the red
˝O˝
button on the ON-OFF switch.
15.2.2
Workflow
1.
Switch on the machine.
2.
Open the top guard.
3.
Position the cut material into the log carriage on the completely extended rocker unit.
4.
Close the top guard again.
5.
Grasp the handle on the left side of the carriage and slide it towards the saw blade cover.
6.
Continue pressing with even force until the cut material has been cut.
7.
After the cut, move the log carriage all the way back again.
8.
If necessary, reposition the cut material and repeat steps 4 to 7 until the work is finished.
