CLEANING, MAINTENANCE, STORAGE, DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
31
ZI-WP500TN
9.
Switch off the machine after work.
10.
Wait until the machine stops.
11.
Disconnect the power plug and clean the unit if necessary.
Free blocked log
If the saw blade is blocked, proceed as follows:
1.
Switch off the machine immediately!
2.
Wait until the machine comes to a standstill
3.
Pull out power plug.
4.
Carefully remove the blocked log from the machine.
16
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
16.1
Cleaning
NOTICE
The use of paint thinners, petrol, aggressive chemicals or scouring agents will damage
the plastic surfaces! Therefore, only use mild cleaning agents for cleaning! Make sure
that no water seeps into the machine!
Clean the machine after each use. Wipe it with a clean, damp cloth or blow off dust and material
residues with compressed air at low pressure. Keep all safety devices, ventilation openings and the
motor housing as free as possible from dirt and dust. Make sure that no water can enter the machine.
The entry of water into a power tool increases the risk of electric shock.
16.2
Maintenance
WARNING
Danger due to electrical voltage!
Handling the machine with the power supply up can
lead to serious injuries or even death. Always disconnect the machine from the power
supply before servicing or maintenance work and secure it against unintentional or
unauthorised reconnection!
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair
the
safety of the user must be rectified immediately!
Repair work may only be carried out by qualified personnel!
To prolong the lifespan of the machine, oil the rotating parts once a month. Do not oil the motor.
16.2.1
Sharpening the saw blade
The saw blade can be sharpened several times without being removed from the machine. Use a
fine-cut square-blade file of 8–12’’ for sharpening.
Pay attention to the following points when sharpening:
•
During manual sharpening only file the front rake of the tooth over a distance of about 5–7
mm.
•
Always keep the original shape of the tooth.
•
Do not make sharp notches at the root of the tooth with the file.
•
Always clean the blade-clamps carefully.
16.2.2
Changing the saw blade
CAUTION
When handling circular saw blades when changing tools, please use safety gloves to
avoid risk of injury.
