CLEANING, MAINTENANCE, STORAGE, DISPOSAL
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
33
ZI-WP500TN
4.
Loosen the fixing screw (7) to release the ring
end of the chain of the locking pin (8) (see Fig. M,
Pic. 1).
5.
Pull the locking pin (8) out of the base frame (see
Fig. M, Pic. 2).
6.
Insert the locking pin (8) into the bore hole (9) on
the outside of the saw blade cover to prevent the
saw blade from rotating (see Fig. M, Pic. 3).
7.
Loosen the M12×30 screw (10) with a saw blade
wrench.
Remove the M12×30 screw (10), the washer (11)
and the flange (12). Detach the old saw blade (13)
(see Fig. N).
8.
The assembly of the new saw blade is done in
reverse order.
CAUTION
Make sure that the saw blade is inserted
in the correct position. The arrow on the
saw blade must point in the direction of
the operating side!
16.3
Storage
•
Disconnect the power plug
•
Store unused machines in a dry, locked place out of the reach of children.
To extend the service lifespan of the machine and ensure smooth operation, carry out the following
before
storing it for a longer period of time:
•
Clean the machine thoroughly.
•
Treat all moving parts with an environmentally friendly oil.
Never use grease! Do not oil the engine!
