TECHNIKA
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Řezačka obkladů / Stone cutting machine ZI-FS115
Strana 16
12
SAFETY
12.1
Intended Use
The ZIPPER ZI-FTS115 is approved for the following stated activities in compliance with the safety
instructions described in this operating and maintenance instructions:
Stone cutting in compliance with all technical limits and all safety regulations.
The improper use or failure to comply with the provisions and instructions detailed in this manual
will void all claims for damages against the ZIPPER GmbH result.
Unauthorized modifications and manipulations of the machine also immediately invalidate all war-
ranty and damage claims.
NOTE:
In addition, the tile cutter ZI-FS115 has a so-called low-voltage release SPE-PRCD which prevents
electrical loads inde-pendently and unexpected turn it back on after a power failure, when power
is available again.
12.2
Safety
Warning signs and / or labels on the machine that are illegible or have been removed are to be
replaced immediately!
The most important factor for adequate security at work is common sense. Care and good judg-
ment are the best protection against injury. This list of general safety information does not pur-
port to include all possible sources of danger, but we have tried to highlight some of the im-
portant details. Individuals should look for caution, warning and danger signs that are marked on
the device and displayed at work and read the safety, understand and heed.
With inexperience, ignorance, fatigue, lack of concentration or under the influence of drugs,
alcohol or drugs that work on the machine is prohibited!
Before each use, check the machine is in perfect condition! Cutting disc condition, tightness
screws etc ...
The regular maintenance and inspection is safety critical.
The machine may only be operated by qualified personnel enrolled. Unauthorized per-
sons, especially children, and people are not trained to keep away from the machine!
Operation of the machine just over 16 years.
When working on the machine zertifizerte appropriate protective equipment
(gloves, work shoes with steel inserts, safety glasses, hearing protection, ...)
wear!
The running machine should never be left unattended! Turn off the machine before
leaving the work area and wait until the engine is at a standstill!
