TECHNIKA
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Řezačka obkladů / Stone cutting machine ZI-FS115
Strana 21
13.2
Mounting the saw blade cover
Mount the bracket using the supplied screws. Fig. 12
Set up in-line with the cutting disc when deviating the receiving plate this.
Fit the blade guard to the mounting plate with the locking screw and the 6-point nut. Fig.13
Make sure that the blade guard does not touch the blade.
14
OPERATION
14.1
Operating instructions:
Put the tile cutter securely on the ground. The cutting blade must not be with the ground or
other objects in conjunction.
Check each time before the blade is in good condition and securely attached
Fill the water reservoir up to the mark with water. Fig. 5
14.2
Operation:
14.2.1
Motor start / stopp
Switch ON
Check that the blade runs freely.
Ensure that the work surface is free of tools and objects.
Turn on the machine by pressing one of the green ON button.
Switch OFF
Run the material from the blade.
Turn on the machine by pressing from the red OFF button.
14.2.2
Notes:
Cut only as fast as it allows the material. If the speed of the cutting wheel in the feed greatly
reduced, slow down the feed!
No lateral pressure on the blade.
No operation without mounted blade guard!
Do not force. Material in the blade Let's eat the material into the blade.
No Dry cutting saw blades are suitable for wet cutting.
No curves intersect.
15
MAINTENANCE
15.1
Maintenance activities:
Make sure that repairs to the motor and the machine are performed by qualified personnel.
Make sure that the plug is removed from the electrical outlet before performing maintenance.
ON
OFF
