OPERATION
32
ZI-ZSM600
15.2.3
Set the cutting height
•
The cutting height can be adjusted with the
locking screw (1).
•
Loosen the locking screw (1).
•
After setting the correct cutting height, re-
tighten the locking screw (1).
15.2.4
Cutting
1.
Workpiece height
NOTICE:
Pay attention to the correct height
of the workpiece.
The max. height of the workpiece is indicated
in the technical data.
•
Take care that the workpiece does NOT
come into contact with the flange (1).
2.
Workpiece fixation
NOTICE:
The workpiece must be fixed on the
brick carrier cart so that it CANNOT slip.
•
This is done by placing the workpiece against
the cross fence (1) of the brick carrier cart.
•
Move the adjustable cross and parallel fences
(2) towards the workpiece and fix them with
the star screws (3).
•
Under no circumstances position the work-
piece (4) on the brick carrier cart as illustrated
on the left.
•
The workpiece should be moved to the saw
blade evenly and at a constant speed.
