TROUBLESHOOTING
37
ZI-ZSM600
16.4
Disposal
Observe the national waste disposal regulations. Never dispose of the machine, ma-
chine components or operating equipment in the residual waste. If necessary, contact
your local authorities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he
is obliged in certain countries to dispose of your old machine properly.
17
TROUBLESHOOTING
WARNIN G
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or death.
Always disconnect the machine from the power supply before maintenance or repair
work and secure it against unintentional reconnection.
Many possible sources of error can be eliminated in advance if the machine is properly connected to the
mains.
If you are unable to carry out the necessary repairs properly and/or do not have the required training,
always consult a specialist to solve the problem.
Trouble
Possible cause
Solution
Wrong rotation direction of
the saw blade
•
The conductive phases at
the connection plug and
the socket do not match
•
Swap two conductive phases, egg. L1 and L2,
at the connection plug.
Machine does not start
•
Disconnection in the cable
connection
•
A missing phase may
come to the electrical
network to which the ma-
chine is connected
•
E-Stop button may be
pressed
•
Check the cable connection
•
Check the fuses on main supply
•
Check the button. If it is pressed release it by
turning it.
Although the water pump
is switched on, water is not
conveyed
•
Water cooling failure
•
Check that there is enough water in the basin
to cover the filter.
•
Check whether the filter is clogged and clean
if necessary.
Unusual noises during
operation
•
Strong noise emission
while cutting
•
Check the saw blade for wear or damage.
•
Change the saw blade if necessary.
