TROUBLESHOOTING
31
ZI-BHS2600
N OTE
Improper storage can damage and destroy important components. Only store packed or al-
ready unpacked parts under the intended ambient conditions!
14.4
Disposal
Do not dispose of your machine in residual waste. Contact your local authorities for infor-
mation on available disposal options. If you buy a new vibratory plate or equivalent from your
dealer, he is obliged in certain countries to dispose of your old machine properly. If you pur-
chase a new machine or equivalent equipment from your specialist dealer, he is obliged in
certain countries to dispose of your old machine properly.
15
TROUBLESHOOTING
WARNIN G
Hot surfaces and rotating machine parts while the engine is running can cause serious
injury or even death. Always switch off the machine before carrying out troubleshooting
work and secure it against unintentional restarting.
If you are unable to carry out the necessary repairs properly and/or do not have the required training, always
consult a specialist to solve the problem.
Trouble
Possible cause
Solution
Engine stalls, is diffi-
cult to start, or does
not start
•
Fuel filter blocked
•
Clean or change
•
Fuel supply blocked
•
Clean
•
Carburettor
•
Contact the service team
•
Incorrect mixing ratio (petrol: 2-stroke oil)
•
Use correct mixing ratio
•
Clean or change the air filter
•
Contact the service team
•
ON-OFF switch is in position „0“ (OFF)
•
Set the ON-OFF switch to position
"I" (ON).
•
Electrical problem
•
Contact the service team
•
ON-OFF switch is blocked
•
Contact the service team
•
Electrode gap of the spark plug
•
Check the electrode gap. This
should be between 0.6 - 0.7 mm.
•
Electrodes of the spark plug contaminated
•
Clean or change
•
Electrodes of the spark plug contaminated
with fuel
•
Clean or change
•
Defective spark plug
•
Change
The engine starts but
stalls or does not ac-
celerate properly
•
Air filter dirty or worn
•
Clean or change
•
Fuel filter dirty
•
Change
•
Fuel vent blocked
•
Clean or change
•
Spark plug dirty or worn
•
Clean, adjust or change
•
Carburettor
•
Contact the service team
•
Cooling system: Excessive and prolonged
operation in dirty or dusty areas.
•
Clean
•
Spark suppressor cracked or contaminated
•
Replace
•
Choke closed
•
Open Choke
Engine does not start
•
Internal engine problem
•
Contact the service team
