OPERATION
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Betontrennschneider / Concrete cutter ZI-BTS350
Seite 26
16
OPERATION
16.1
Engine Start
Place the concrete release cutter safely on the ground. The blade must not be to the ground or
other objects together.
Before the blade, no persons are allowed to stay there.
NOTE: Remove at least 3m from the refueling.
16.1.1
Cold start:
Press the ON-OFF switch to the "ON" position
Adjust the combi-switch (2) the corresponding position.
At restart the combination switch (2) in to be adjusted to the "Choke"
Position.
On a warm start of the ˝Choke˝ is not used. The combi-switch remains in the
Position.
Press with your hand on the handle above the switch (3) of the throttle lever (4). Then push
the throttle lever (4) up.
Press with your thumb throttle-lock button (5) and leave at the same time the throttle lever
to the lock button can lock.
Press the the decompression (1) button.
Hold the front hand lever with one hand and press with your foot to the lateral pedal to the
floor.
Start Cable: Cable tighten until resistance can roll back and then forcefully put in a train.
If the engine according to the third Tightening does not start, open the choke slightly.
Falls der Motor nach dem 3. Anziehen nicht anspringt, Choke etwas öffnen.
The combi-switch after the first engine noises flammable placed in the
position.
If the engine is running throttle lever (4) Press briefly to dislodge the lock button and the
full throttle position is changed to idle.
ON-OFF switch
