MAINTENANCE
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Betontrennschneider / Concrete cutter ZI-BTS350
Seite 28
No Dry cutting saw blades are suitable for wet cutting.
No curves intersect. Not inclined to fix blade material.
17
MAINTENANCE
17.1
Maintenance activities
Check the engine oil level before each use
Check the belt tension and adjust as required by these-6.1.3-
Lubricate the bearings of the diamond saw blade axis daily
Before each use, the blade is in good condition and tight fit
Before each use the air filter is clean.
Before each use screw connections for tightness
Air filter (every 100 hours)
1.
Remove the air filter.
2.
Clean it in a solution.
3.
Drops of engine oil on the air filter.
4.
Waste engine oil to remove from the air filter by wring it out.
CAUTION: NEVER WITHOUT ENGINE AIR FILTER OR MAINTAINTED
AIR FILTER WITH NOT OPERATE
.
17.2
Spark plug (every 50h)
Remove the spark plug contact.
Remove any debris with a brush.
Inspect the spark plug for discoloration.
Check the contact gap. Standard: 0.7 ~ 0.8mm
17.2.1
Cleaning
N O T E
Cleaning: The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners
will result in damage to the surface!
Therefore:
When cleaning, use only mild detergent
(Picture 18)
0.7~0.8
(Picture 19)
