ASSEMBLY
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Seite 27
Gartenhäcksler / Garden Shredder ZI-GHA2000
15.1
Start up
Make sure that the device is completely and correctly assembled.
Set the shredder for use on firm, horizontal ground (tipping).
Use the device only in the open. Keep a safe distance (at least 2 m) from a wall or other rigid object.
Check before each use:
-
the connection cables for defects (cracks, cuts, etc.) do not use damaged cables
-
the device for damage
(see Safety)
-
that all screws are tightened
15.2
Electrical Connection
15.2.1
Earthing Connection
A T T E N T I O N
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore: Machine must be operated in a grounded power outlet.
The supply voltage must comply with the specifications that are listed on the nameplate of
your harvester. Chopper with a nominal value of 230 V can be connected to a mains voltage
of 230V.
The chopper is to be supplied via a residual current protective device with a tripping current
not exceeding 30 mA.
An extension cord with too small a cross section causes a significant reduction in the efficiency
of the machine. For cables with a length of up to 25 m, a diameter of at least 3 x 1.5 mm
2
is
required, for cables with a length of about 25 m, the cross section must be at least 2.5 mm
2
Note!
When starting (start) this equipment, a brief voltage drop occur, especially in poor network
quality. These dips can affect other devices (eg flicker of a lamp). For a line impedance
Zmax 0.42HM such disturbances are not expected. (Please contact you their local power
company for further information).
