Z.I.P.P.E.R MASCHINEN GmbH
www.Zipper-maschinen.at
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
Seite 44
• Access while it is working in the cutting tools.
• Make sure that they do not come under the cutting tool! Always use the correct
cutting tool for the work to be done.
• Do not wear loose clothing that may get caught in moving parts.
• Turn off the cutter when the machine for transport across another surface must be
tilted than grass and when transporting the machine to and from a machined
surface.
• Disengage the cutter before the start
• Start or press the starter with caution according to the instructions and pay
attention to allow sufficient distance between the feet to the cutting elements
• If the machine has to be tilted at the start, lift only the side facing away from the
operator side high
• Within a radius of 15m, no other people and animals may
be!
• This distance also adhere to things!
• Risk of material damage!
• Do not use the twig saw in the vicinity of cables, power or telephone lines.
• Hold when working with the branch saw a safety distance of 10m to aboveground
live lines.
♣
The running machine should never be left unattended !
Stop the motor upon completion of working, as well as any break.
♣
Never lift or carry the machine with the engine running
♣
When the engine is running or hot , never let the fuel cap be removed
Switch off the machine , disconnect the spark plug on machines with battery and
start the ignition key and allow the unit to cool down and come to a standstill :
♣
Before you check the machine clean , store or carry out work on him
♣
Before you resolve blockages
♣
If a foreign object , inspect the machine for damage and perform the necessary
repairs before you restart the machine and work with it
♣
If the machine begins to vibrate abnormally or the operation noise amplified ,
investigate immediately and check for loose parts and tighten any loose parts. Before
restarting the work first and make necessary repairs
♣
Before you set the working position of the cutter
♣
Before you refuel
♣
However, if you leave the machine
HEDGE TRIMMER:
• Not to pick up objects using
• cutter running after the release of the throttle control (free-wheeling).
• Cutting always start with running cutter
