OPERATION
Z.I.P.P.E.R MASCHINEN GmbH
www.Zipper-maschinen.at
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
Seite 47
13.2.6
Operation brush cutter
Changing the mowing attachment
For the blade you have to use the nut.
The trimmer is fitted by the threaded hole.
Operation with the blade (Fig. U)
Start the machine. Now hang the belt round your neck. Operate the throttle handle and
start mowing like shown on the picture.
Operation with the trimmer
Do those like mowing with the blade.
13.2.7
Operation twig saw (Fig. V)
Take care that you aren’t standing under the twig you want to cut.
Remove the safety cover.
Start the engine.
Hang the belt around your neck.
Position the saw where you want to cut.
Operate the throttle handle and cut the twig carefully from the upper to the lower side.
13.2.8
Operation hedge trimmer
Adjustment of the cutting angle (Fig. G)
Push the lock handle
14
. Then operate the handle
15
. Now turn the hedge trimmer to the
required position. Stop pushing the handles. Take care that both latch into position.
Horizontal cuts (Fig. W)
Adjust the required cutting angle. Remove
the safety covers. Start the machine and
hang the belt round your neck. Now cut the
hedge like shown on the picture.
Vertical cuts (Fig. X)
Do this like cutting horizontal cuts. Cut the hedge like shown on the picture.
N O T I C E
Release the throttle lever in dangerous situations (engine stops) and slip from,
worn only on a shoulder strap, put the machine down and remove from the
danger zone.
