MAINTENANCE
Z.I.P.P.E.R MASCHINEN GmbH
www.Zipper-maschinen.at
Gartenpflegeset / Garden maintenance set ZI-GPS70G / ZI-GPS182G
Seite 49
14.1.5
Changing the shears
At first you have to loosen the nuts
35
and
36
(Fig. a).
Now remove the nuts
37
(Fig. b).
Then dismantle the guiding bar
38
(Fig. c).
Now loosen and remove the screws
39
(Fig. d).
Loosen the socket screws
40
and remove the cap
41
(Fig. e).
Then you have to disassemble the gasket
42
and the safety cover
43
(Fig. f).
Now lift the connecting rod
44
out of the cam gear.
Take care that you do not lose the spacer
45
(Fig. g).
Now you can change the shears (Fig. h).
For fitting the new shears you have to do these steps backwards.
14.1.6
Lubrication
After cleaning you have to lubricate all the moving parts. Spray the chain with a chain spray.
Every 15 working hours you must squeeze some grease into the grease nipples of the twig saw
31
(Fig. E) and of the hedge trimmer
32
(Fig. G).
14.1.7
Storage
When the machine is stored longer than 30 days:
Drain the fuel out of the fuel tank.
Take off the spark plug and pour some drops of oil into the cylinder. Turn the engine
some times using the cable control so the oil in the cylinder gets evenly distributed.
Clean the spark plug and fit it again.
Cover the machine and store it at a dry and clean place.
14.1.8
C
ontrolling the oil level
Before using the twig saw you have to control the oil level of the oil tank
30
for the twig saw (Fig.
E). Refill it when there’s too less oil in it.
