ASSEMBLY
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Seite 31
HOLZSPALTER / LOG SPLITTER ZI-HS8PT / ZI-HS10T / ZI-HS12T
13.2.3
Mount wheels ZI HS10T / 12T
Insert the screw M10x20 the screw retain-
ing ring, washer and put the wheel on.
Then insert is the small and then the large
washer on.
Let tilt the machine from a second person
easily.
Insert the pre-assembled wheel on the base
frame and tighten it with a wrench -17 - so
tight that it can still be turned.
13.2.4
Hydraulic
The log splitter is equipped with a hydraulic oil tank in the base plate and is factory filled with oil.
CAUTION: When not upright transfer of the log splitter, oil can escape through the bleed screw.
At low ambient temperatures, the hydraulic oil assumes a thick consistency.
THEREFORE: Especially at low ambient temperatures, a minimum idle time of 3 minutes be-
fore carefully before EVERY use! Do not burden at this time the log splitter! Lifting and lower-
ing you now about 10 to heat the slit assembly
times without stress to the hydraulic oil.
Failure to follow this policy may result in damage
to the hydraulic system and the warranty is ex-
cluded.
ATTENTION:
Slightly open the oil filler cap
at ZI-HS8PT during operation
to compensate for pressure !
Loosen the
Oil filler cap
only at
ZI-HS8PT
