TECHNICAL INFORMATION
ZIPPER MASCHINEN GmbH
Seite 21
Vibrationsstampfer / Vibrating tamper / Pison vibrador / Pilonneuse ZI-RAM80V
ite 21
10
TECHNICAL INFORMATION
10.1
Machine Description
ZI-RAM80V
A
Throttle control
To adjust the engine speed
B
Choke
Apply by a cold start of the engine or generally in cold weather. The
choke enriches the fuel mixture.
C
Fuel cock lever
OPEN – fuel can circulate CLOSE – fuel flow stopped
D
Engine main switch
ON – engine can be started OFF- ignition break
E
Recoil starter
To start the engine
F
Throttle lever
To adjust the engine speed (directly at the engine)
G
handle
Control the vibrating tamper by holding the Handle with both hands.
H
Transport-/Lifting
Hanger
When lifting, only by this.
I
Tank cap with filter
insert
Refuel only with filter, do not refill during motor and muffler is very
hot.
J
Air filter
Protects the fuel circuit from dust and other debris. Loosen and re-
move wing nut on air filter cover to remove and to check/clean the
air filter.
K
Protection frame
Protects the motor assembly in the case that the machine tumbles
down.
L
Oil tank and oil drain
screw
Check oil level on a regular basis. Add oil if necessary.
Change motor oil after first 20 operation hours and later every 100-
operation hours.
M
Tamping assembly
Converts motor rotation into vibration
N
Absorption assembly
Reduces the vibration level
O
Compactor plate
Clean from debris after operation
P
Transport wheels
To transport for short distances
