24
Z I PP I E XP R E SS
Attaching Headrest Pad
a. Remove vinyl collar cover and insert over the knurled headrest ball.
b. Loosen collar screws (A) enough to slip collar onto knurled ball.
c. Be sure to evenly tighten the collar by first loosely starting the screws.
d. Using the 5/32” hex key, tighten the screws 1/2 turn alternating between the two
sides until there is an even gap as shown (Correct alignment). Make sure collar align-
ment is even and secure. If the collar is unevenly tightened as shown (Incorrect align-
ment), injury to the child could result
P. HEAD SUPPORTS (Option)
Installation
a. Using a hex key Loosen the rear occipital screwball (B), adjust up or down to provide
slot access.
b.
Remove the bolt and washer (C) from the mounting plate.
c. Fit the mounting plate to the front of the occipital mount slot as shown. Plate can be
mounted above or below occipital pad.
d. Replace the bolt and washer and tighten.
Forehead strap adjustment
a. Using an Allen wrench: Loosen the guide rods adjustment screw (D), and slide both
guide rods evenly to desired diameter.
b. Locate neoprene strap (E) in desired position on forehead.
c. Slide guide rods through clamp until front of neoprene strap is approximately 1/2”
from plastic guide support (F). Strap must fit snuggly on forehead. (G).
d. Re-Tighten guide rod adjustment screw to hold position.
e. Guide rods may be trimmed to 1” limiting rearward protrusion.Vinyl caps should be
removed prior to trimming and then reinstalled. (H)
f.
Re-adjust forehead strap as necessary.
Downward stop angle adjustment:
a. Using an Allen wrench loosen the angle adjustment clamp screws ( I ).
b. Insert an Allen wrench into the exposed hole ( J ) on the silver angle adjustment pivot
and rotate until the forehead pad and guide rods are at the desired angle.
c. Re-tighten the angle adjustment clamp screws and check all settings.
Notice:
Fasteners and Headstrap adjustment should be checked prior to each use. Neoprene Strap
must be replaced at the first signs of wear or loss of tension.
53
52
51
IX. DEALER SERVICE & ADJUSTMENT
52
53
54
G
51
Incorrect Alignment
Correct Alignment
A
B
D
E
H
E
C
F
I
J
9921700000 Rev. E
