Zippity Pet or Garden Enclosure Kit Instructions
4
1
2
Gate Assembly
Identify the gate top and bottom rail.
Insert the gate posts into the routered holes as shown.
Note
that the tab is at the top.
Align the pre-drilled holes on the rails with the pre-drilled
holes on the post and fasten each intersection with two
short screws (one from the front and one from the back)
except for the front right on the top rail - this is where the
latch will eventually go.
STEP T WO
1
Gate Top Rail
Gate Bottom Rail
Top
Bottom
Top
Bottom
3
2
Note: Post Tabs
3
Align H
oles
NO DIG GARDEN FENCE & SCREENS
Zippity
Tip!
Shine an LED light from your smart phone or flashlight
down the end of the posts to help identify alignment of
pre-drilled holes if necessary.
Small holes routed through the top and bottom of the rail.
Small holes only routed through the top of the rail.
Note: No Pre-drilled Hole
Latch will eventually be
installed here.
