13
The decks should have two coats of epoxy on the
underside of them.
Scrape the bottom of these decks so that the epoxy is
smooth. Check the fit all around.
When you are satisfied that they fit everywhere, glue
them down.
Use 30 minute epoxy, and don't be stingy. Tape and
weight the deck in place and wipe away excess epoxy.
Work quickly.
Be sure the deck is pushed up against the balsa nose.
Check back periodically to be sure the deck has not
creped outward.
Wipe away any epoxy that has oozed out.
Repeat on the other side.
Allow to cure.
Sand off the deck overhangs on the side and rear.
Round the balsa nose.
You only have to round the front of the decks.
You can leave the balsa square in the center.
The cowling will cover this.
Sand the sponson insides and sand the fuselage outsides
until they are flat and smooth.
Use a 3/16 drill bit to clean out all of the dowel holes if
needed.
Sand a point on one end of each dowel.
Use 30 minute epoxy to glue ONE sponson in place.
Summary of Contents for G30
Page 1: ...1 G30 Outboard Tunnel Hull For 21 Nitro or 4S electric Length 30 5 inches Beam 11 5 inches...
Page 24: ...24...
Page 25: ...25...