14
UC5 IM 1-6 April 2002
Installation Procedures for Interface Kits
NOTE:
1)
The UC5 Controller is designed for all Digital Duplicators.
2)
Numbers in parentheses ()in the installation procedures correspond to
the part numbers on pages 8 to 10.
Model C229, C232 and C233
Refer to Driver Groups List on page 7
NOTE: The interface kit is required. If the kit is standard you must
perform step 3 only to connect the controller .
1. Remove the rear cover and right side panel of the Digital Duplicator.
2. Mount Printed Circuit Board (32)
on connector CN102 of the MPU
board using two M3x6 screws (35).
Mount the cable (33) on the Con-
nector Bracket using two stepped
screws (34).
3. Remove the blinding cover in the
right side panel.
NOTE:
Select A3 for paper size in initial set-
ting (the default setting is Auto).
The On-line key is enabled automati-
cally when the controller and interface
kit are installed.
CN102
Printed
Circuit
Board
Harness
Connector Bracket
Binding Cover
