15
UC5e IM Rev 2-1 July 2004
Model C252
Refer to Driver Groups List on page 8
Accessory Check
Check the quantity and condition of the accessories in the box against the
following list:
Description
Qty
1. Interface Board ................................................................... 1
2. Interface Cable.................................................................... 1
3. Screw M3 x 6 ..................................................................... 2
4. Lock Screw ......................................................................... 2
5. Washer ................................................................................ 2
Installation Procedure
1.
Remove the rear cover [A]. ( Screws x 5)
2.
Remove the I/F connector cover [B]. (Screws x1)
3.
Connect the I/F board [C] (accessories) to CN108 [D] on the MPU.
(Screws x 2)
4.
Attach the cable [E] (accessories) to the connector bracket. (Screws x 2)
5.
Connect the connector [F] at the opposite end to the I/F board.
6.
Re-install the rear cover.
[A]
[B]
[C]
[D]
[E]
[F]
