997-532-000-1, Issue 1
March 2006
1
EN54 & ISO 7240 2-8 Zone Conventional Fire Panel - Installation & Configuration Manual
1
Introduction
1.1
Manual Purpose
The purpose of this manual is to provide the user with
all recommended procedures and full technical details
for the successful installation, commissioning and
configuration of the EN54 (and ISO 7240) 2-8 Zone
Conventional Fire Control Panel.
The descriptions and procedures apply to the Bardic by
Honeywell Zircon 2-8 Zone fire alarm control panels.
Procedures described in this manual include appropriate
warnings and cautions to guide the user towards adopting
safe and methodical work practices during the
installation, commissioning and configuration phases.
Important Note
This manual must be read, and its contents clearly
understood, before proceeding with any work relating to
the control panel. Damage to the control panel may result
from NOT following the recommended procedures
described in this manual.
If there are any areas of doubt, consult your supplier
before continuing with the system installation,
commissioning and configuration.
1.2
System Design and Planning
It is assumed that the system, of which this control panel
is a part, has been designed by a competent fire alarm
system designer in accordance with the requirements of
EN54 Part 14 and any other local codes of practice, such
as BS5839-1, that are applicable. The design drawings
should clearly show the positions of the field devices and
the control equipment.
1.2.1
Personnel
Installation of this product must be carried out only by
suitably-qualified electrical engineers.
1.3
General
The control panels are factory-configured either as 2, 4 or
8 zones. The panel has been tested and manufacturer-
approved for use with the following devices:
Zircon Detector Range
System Sensor: ECO1000, PhD/Series 800 & Vision.
The panel is self-contained with integral power supply and
space provision for two sealed, lead-acid standby batteries
and complies with the requirements of EN54 Parts 2 and 4.
The panel functions are microprocessor controlled and test
and disable functions are included. Provision is made for
activating up to a maximum of four (with 2-way Relay PCB
fitted) sounder outputs and day/night mode working.
Provision is also made for up to 2 optional 8-way Relay
PCBs which can provide a further 8 or 16 configurable
relay outputs.
Summary of Contents for EN54
Page 41: ......
