12
12
CHAPTER
SAFETY AND RESIDUAL RISKS
SERVICE
If any points of these instructions remain unclear to the customer or if indications,
instructions, safety instructions or technical explanations have not been fully understood,
FQPQVJGUKVCVGVQEQPVCEV<KTMQP\CJPŏUJGCFQHſEGRJQPGQTGOCKN
KPHQ"\KTMQP\CJPEQOQTVJGUGTXKEGEGPVGTUURGEKſGFKP[QWTOCKPVGPCPEGEQPVTCEV
PURPOSE
The intended use of the Face Hunter is outlined in this chapter.
In this connection a hazard analysis was carried out on the Face Hunter. The manufacturer does
not accept any responsibility for applications not described here which do not fall within the
FGſPKVKQPQHKPVGPFGFWUG6JGOCPWHCEVWTGTFGENKPGUCP[TGURQPUKDKNKV[HQTVJKU
Intended use
The Face Hunter is an optical scanner for capturing faces in 3-D and for taking 2-D images
on the basis of which the planned restoration is then positioned and modeled.
Obligations of the user
The operator must make sure to:
- Prevent abuse.
- Operate the system only with all intended safety devices closed and intact
(security switch, side covers etc.).
- Disconnect the Face Hunter from power supply by pulling the mains plug before
any intervention.
Summary of Contents for Face Hunter
