14
Assembly Instructions
Unfold the Baby Stroller
• Take the stroller out of the package as shown in Fig. 1a
• Unfold the folding hook, pull the handlebar and gradually push to
open the stroller until a „click“ sound is heard as shown in
Fig. Ib and 1c
Install the Front Wheels
As shown in Fig. 2, attach each wheel to
the front wheel axle till a “click”
sound is heard.
Install the Rear wheel
As shown in Fig. 3, insert the rear wheels
into the rear wheel axle till a „click“ sound
is heard and ensure the rear wheels are
locked and cannot be pulled out.
1а
1b
1c
3
2
Folding Hook
13
Assembly Instructions
Unfold the Baby Stroller
• Take the stroller out of the package as shown in Fig. 1a
• Unfold the folding hook, pull the handlebar and gradually push to
open the stroller until a „click“ sound is heard as shown in
Fig. Ib and 1c
Install the Front Wheels
As shown in Fig. 2, attach each wheel to
the front wheel axle till a “click”
sound is heard.
Install the Rear wheel
As shown in Fig. 3, insert the rear wheels
into the rear wheel axle till a „click“ sound
is heard and ensure the rear wheels are
locked and cannot be pulled out.
1а
1b
1c
3
2
Folding Hook
13
Abb. 01
Heben Sie die beiden Schutzklappen
an den Ecken an und schliessen Sie
die Reißverschlüsse vollständig.
Abb. 02
Führen Sie die Rohre wie in der
Zeichnung gezeigt in die
Halterungen ein und verbinden Sie
diese.
Open the pocket and unfasten
the velcro straps.
Fig 1
Fig 2
Draw upward the four top rails separately,starting with short sides
first and lift the middle joint up to completely expand it.
When completely expanded ,you will hear a "click" sound.
do the same for the long sides.
Completely flatten the middle parts in the centre
of the baby playpen completely flatten the middle parts
of the side rail tubes.
Fig 3
Fig 1
Lift the two protective flaps found on
zips fully to their respective ends.
the two corners and pull the
Insert the tubes into their holders
in the base of the support as shown
in the drawing. Fit the tubes together.
TO ASSEMBLE THE SECOND LAYER
Fig 2
TO OPEN THE BABY PLAYPEN
Open the pocket and unfasten
the velcro straps.
Fig 1
Fig 2
Draw upward the four top rails separately,starting with short sides
first and lift the middle joint up to completely expand it.
When completely expanded ,you will hear a "click" sound.
do the same for the long sides.
Completely flatten the middle parts in the centre
of the baby playpen completely flatten the middle parts
of the side rail tubes.
Fig 3
Fig 1
Lift the two protective flaps found on
zips fully to their respective ends.
the two corners and pull the
Insert the tubes into their holders
in the base of the support as shown
in the drawing. Fit the tubes together.
TO ASSEMBLE THE SECOND LAYER
Fig 2
TO OPEN THE BABY PLAYPEN
22
1
Den Rahmen zusammenbauen
