15
Assembly Instructions
Unfold the Baby Stroller
• Take the stroller out of the package as shown in Fig. 1a
• Unfold the folding hook, pull the handlebar and gradually push to
open the stroller until a „click“ sound is heard as shown in
Fig. Ib and 1c
Install the Front Wheels
As shown in Fig. 2, attach each wheel to
the front wheel axle till a “click”
sound is heard.
Install the Rear wheel
As shown in Fig. 3, insert the rear wheels
into the rear wheel axle till a „click“ sound
is heard and ensure the rear wheels are
locked and cannot be pulled out.
1а
1b
1c
3
2
Folding Hook
13
Assembly Instructions
Unfold the Baby Stroller
• Take the stroller out of the package as shown in Fig. 1a
• Unfold the folding hook, pull the handlebar and gradually push to
open the stroller until a „click“ sound is heard as shown in
Fig. Ib and 1c
Install the Front Wheels
As shown in Fig. 2, attach each wheel to
the front wheel axle till a “click”
sound is heard.
Install the Rear wheel
As shown in Fig. 3, insert the rear wheels
into the rear wheel axle till a „click“ sound
is heard and ensure the rear wheels are
locked and cannot be pulled out.
1а
1b
1c
3
2
Folding Hook
13
Abb. 01
Drücken Sie die Federtaste am
Ende, um die Stahlrohre zu
verbinden. Beim Einrasten ist ein
“Klicken” zu hören ist. Schließen
Sie alle Rohre entsprechend an.
Befestigen Sie die Wickelauflage
am Rahmen und stellen Sie sicher,
dass diese stabil ist.
Abb. 02
Führen Sie beide Plastikclips,
wie in der Abbildung dargestellt,
in die Öffnung ein, und
befestigen Sie diese auf die
kurzen Seitenschienen des Baby-
Reisebetts.
Press the spring key to join the steel tubes
until a "click" is heard. Connect all tubes appropriately.
Buckle the changer onto the handrails and ensure
the changer is stabilized.
Insert the two plastic clips into the hole as the shown way.
place the two clips on the short side rails of the baby playpen.
CANOPY MOSQUITO
CHANGER AND STORAGE LAYER
Fit the 2 hooks as shown in the figure so that
the hood is correctly fitted.
Fix the hood at the back to the 2 press studs placed
at the 2 rear tubes.Pull the mosquito net to the opposite
part as shown to cover the corners.
Fig 1-2-3
Fig 1
Fig 2
Press the spring key to join the steel tubes
until a "click" is heard. Connect all tubes appropriately.
Buckle the changer onto the handrails and ensure
the changer is stabilized.
Insert the two plastic clips into the hole as the shown way.
place the two clips on the short side rails of the baby playpen.
CANOPY MOSQUITO
CHANGER AND STORAGE LAYER
Fit the 2 hooks as shown in the figure so that
the hood is correctly fitted.
Fix the hood at the back to the 2 press studs placed
at the 2 rear tubes.Pull the mosquito net to the opposite
part as shown to cover the corners.
Fig 1-2-3
Fig 1
Fig 2
22
1
Wickelauflage
