2. Adjust the backset of the lock to 70mm (if needed)
Pull-out the Faceplate
Rotate the Faceplate
By default, the metal shaft twists over the center as shown:
60mm backset
Press the Bolt inside the Latch
70mm backset
Rotate it back
3
3. Latch Installation
1
1
2
UP
UP
Backset is the distance from the edge of the door to the center of the hole drilled on the door. The default
Backset is 60mm, but if you want to change the Backset to 70mm, grasp body and twist the Faceplate as
shown below:
Before installing the Latch,
make sure the Latch Bolt is
in
retrac ted(Unlocked)
position and the arrow is
facing upwards.
Secure the Latch by inserting the B screws.
