BG500 Series Barrier Gate
User Manual
P a g e
|
25
Copyright©2022 ZKTECO CO., LTD. All rights reserved.
7
The radar detector signal is
not working
1. Wrong signal wiring
2. Distance and environment
learning is not correct
3. Detector damage
1. Connect according to
the wiring diagram
2. Complete the
installation test
through the radar
installation video or
the user manual
3. Replace new radar
detector
8
Abnormal shaking of the
barrier boom occurred
while opening and closing
Spring too tight or too loose
and the running speed too
fast
If the boom arm open
shaking, it is necessary to
loosen the spring and slow
down the speed
appropriately; If the boom
arm close shaking, it is
necessary to tighten the
spring and slow down the
speed appropriately.
9
The boom is not vertical
and parallel after opening
or closing
1. The spindle is not properly
calibrated
2. Encoder travel limit error
1. Loosen the screw on
the spindle connecting
arm and then adjust
and calibrate the
spindle direction
2. Adjust travel limit
parameters again
10 Abnormal sound is heard
when the motor is running
1. Motor rotor bearing is
being damaged
2. Operating handle broken
1. Replace new motor
2. Replace the new
operating handle