BGM1000 Series Barrier Gate (APP Version) User Manual
P a g e
| 9
Copyright©2023 ZKTECO CO., LTD. All rights reserved.
5
Installation Procedure
Installation Precautions
5.1
1.
Install the parking barrier on a flattened ground. A cement foundation is required
before installation if the ground is not solid and flat.
2.
It is possible to reduce the length of the boom arm, but it cannot be increased. After
the boom arm has been cut, it is important to set the spring balance again to achieve
a new balance. The bottom of the spring contains two plastic nuts designed to adjust
the new balance.
3.
When powered on, do not change the wire connection inside.
4.
Connect the GND to the cabinet for ensured protection.
Cable Embedding
5.2
1.
A φ25 protective sleeve and a cable are required.
2.
The route cables must pass through the protective sleeves.
3.
Use a tool to open the cable tray on the ground.
Minimum
depth:100mm
