FBL6000 Pro series installation guide 3
3 Electric and Civil Installation
1. Device installation conditions
The location where the device is installed must be a concrete flat surface so that the expansion
screws can be fastened firmly. If the planned foundation does not meet this criterion, consult
professional building or decoration personnel and create stable conditions for firmly fastening of the
wing gate.
2. Determination of the location of device installation
Decide the installation location based on the space needed as illustrated in Figure 3-1A and Figure 3-
1B.
Figure 3-1A Single-Passage Wing Gate
Figure 3-1B Dual-Passage Wing Gate
3. Cable connection
For the location of the hole where the cables come out, please refer to Figure 3-2 below.
4. Device installation
a) Turn on the master machine and slave machine, adjust the wing arms to ensure that the wing
arms are in the same line and the distance between wings is 50 mm. Turn the wings to the OFF
state.
b) Test whether the infrared rays transmitted by infrared sensors on both sides align with each other.
