Barrier Gate-ProBG3000 Series
User Manual
P a g e
| 5
Copyright©2020 ZKTECO. CO., LTD. All rights reserved.
2.4
Boom Installation
•
Place the boom into the boom tray head according to the hole location.
•
Use the spanner to clamp the round boom by screws, gasket, and screws nuts.
Fig. 2.4
3
•
Based on the standard guidelines set for the booms, all of the barrier gates are set up in the factory
accordingly.
•
The spring used in the mechanism is in a highly tense state. And all the adjustments of the barrier
must be carried only after the spring is in a loose state.
•
Please check the stiffness and placement of the boom after it is installed and operated for the first
time.
•
Once the weight of the boom is balanced by the tension applied by the spring, the barrier gate can
be operated properly. Therefore, if any change is applied (for example: after exerting excessive
force) to the boom it must be re-adjusted in accordance with the steps mentioned below.
