SBT2000S Swing Barrier Turnstile
User Manual
P a g e
| 10
Copyright©2020 ZKTECO CO., LTD. All rights reserved.
buried 100mm under the ground, with the height of the exposed part about exceeding 100mm. In
addition, the conduit outlet is bent back to prevent ingress of water into the conduit.
SBT2000S installation holes and cabling positions are shown in the below figure.
Mark out the screw holes at the center of the stand, and the edge of the chassis base on the ground
according to the sizes (as shown in the above figure). Use a hammer drill to perforate M12 screw holes and
then install the screws. Place the swing barrier turnstile according to the sizes and positions as shown in
the figure before installation and fixation. Then, connect all the cables and perform the power-on test. If
the test is OK, tighten the screws. It is recommended that a warning line be marked out on the ground
after the barrier is installed, so as to prompt the pedestrian to stand behind the warning line when swiping
the card. (as shown in below figure).
