Chapter 2 The installation of the product
2.1 Installation notes
2.1.1 It is recommended that the swing barrier turnstile should be installed on a cement platform with
50mm to 100mm in height.
2.1.2 It is recommended that the swing barrier turnstile should not be used in corrosive environment.
2.1.3 Make sure the protective earth wire of the system is reliably connected to avoid personal injuries or
other accidents.
2.1.4 After installation, check whether connection is reliable at the connecting points of the protective
earth wire, at the connector assemblies and wiring points of the circuits, as well as at each movable part
of the swing barrier turnstile. Any loose nuts, screws and other fasteners should be tightened in time to
avoid swing barrier turnstile failures caused by long-time operations.
2.2 Installation position of the swing barrier
The installation position depends on the size of the swing barrier.If the swing barrier turnstile is installed
near a wall, a distance from100mm between the swing barrier turnstile and the wall needs to be reserved
for ease of opening the top cover of the machine to perform maintenance and adjustment. The master
and slave of a SBTL2000 swing barrier turnstile may either form a channel, or form two channels with a
SBTL2200 swing barrier turnstile,as shown in figure 2-2A;
Figure2-2A SBTL2000 Single channel and dual channel
Summary of Contents for SBTL2000
Page 14: ...12 ...
