SBTL8000 series User Manual
5
2.
Installation of the Product
2.1
Installation notes
1)
It is recommended that the speed gates must be installed on a horizontal solid platform with a
height of 50mm to 100mm.
2)
It is also recommended that the swing turnstile should not be used in a corrosive environment.
3)
Make sure the protective ground wire of the system is reliably connected to avoid personal
injuries or other accidents.
4)
The equipment shell is made of stainless steel. You may gently remove any dirt or dust on the
surface with a soft and smooth fabric. Do not scrub the surface with hard objects. Do not rinse
the device with water, otherwise there may be short circuit or damaging the equipment.
5)
After installation, check if the connection is done correctly at the connecting points of the
protective ground wire, at the connector assemblies and wiring points of the circuits, as well as at
each movable part of the speed gates turnstile. Any loose nuts, screws and other fasteners should
be tightened in time to avoid speed gates turnstile failures caused by longer operations.
2.2
Installation position of the speed gates
A distance of 100mm between the speed gates turnstile and the wall needs to be reserved for ease of
opening the top cover of the machine to perform maintenance and adjustment. The reference figure
is shown below:
