4
Figure 3-3
3.3 Installation
1.
Drilling holes.
Drill holes based on the locations of the holes shown in Figure 3-3.
2.
Fix the mounting plate to its original position.
Placing the mounting plate properly and apply screw securing glue on the surface and the threads of the expansion
bolts, install four expansion bolts to secure the mounting plate, and use a horizontal ruler to test the levelness of the
mounting plate. If the mounting plate is not level, adjust it by the gaskets provided. Note that all the four expansion
bolts must be installed properly, as shown in Figure 3-4.
Figure 3-4
3.
Put the turnstile on the mounting plate and tighten the screws. Apply screw securing glue before using and putting
gaskets on the screws to adjust the direction of the turnstile. If the tripod turnstile is not level, you can place gaskets to
adjust, as shown in Figure 3-5.
Figure 3-5
Screw securing glue shall
be applied on the threads.
Installation levelness
Installation levelness
