4
The default configuration of the Standalone Terminal is as follows:
Demo Using Instructions:
Connect the USB port of the Standalone Terminal to the USB port of the computer.
The power adapter is recommended to use the DC12V/3A specification. Power supply to the
Standalone Terminal and the buzzer sounds once.
In the computer to open Demo, click ’Connect’, on the right side of the middle will show
‘Connect Successful’ , and machine and demo connection success.
Wiegand Interval Time: Sets the time interval between adjacent wiegand data.
Reader Indicate: Set whether the buzzer rings when the machine is on the electricity and
brush the card.
Work Mode: Set the working mode of the machine, and including always read mode, trigger
mode. Under trigger mode, time of reading card can be set when it is triggered once.
RF Setting: Set the RF parameters of the machine, including power, spectrum. Power range is
Work Mode
Always Read
Read Tag Interval Time
0s (Default)
Wiegand Out Setting
wiegand 26; Forward Output; 9th Start Byte(Default);
Wiegand Interval Time
2s (Default)
Output Power
18dBm~26dBm
Working Frequency
902MHz ~928MHz (American Standard);
865MHz ~ 868MHz (European standard)
