5
2.Communication Ports
2.1 Universal Serial Bus(USB Port
)
Connect the printer with the standard USB cable (usb device types are
automatically), once printer is connected with the PC, install the driver , then
choose the corresponding port accordingly.
2.2 RJ45 Ethernet Port (10M/100M)
(suitable for 80-III type)
With this port, we can use the network cable and connect the computer directly,
communication and the port number is 9100;
2.3 RS232 Serial Port
RS-232 is developed according to the EIA standard asynchronous transmission,
the specification as following:
z
Data transmission: serial interface
z
Synchronization: asynchronous
z
Signal Level: +5.4V Serial RS232 Level, logic 1:-5.4v, logic 0: +5.4V
z
Hardware Flow Control: Hardware
z
Baud Rate:9600bps to 115200bps( Optional )
z
Data Length: 8 Bits
z
1bit Stop Bit: 1Bit
z
Parity: None
The wiring method of the serial interface printer following the standard rules of
Serial Interface EIA standard. Consumer can get the current default baud rate
from “ Print Test Page ”and also can adjust the baud rate via DIP switch ( DIP
switch is on the bottom of the printer )
